Preparing Unit for Drive Installation
IMPORTANT: If this upgrade requires the replacement of the DX8000Õs primary hard disk drive (drive 1 nearest the CD/DVD drive), refer to the instructions for replacing the primary drive (manual number C1606M). This manual should be included with this upgrade kit if a primary drive replacement is necessary. Many of the steps are the same for replacing the primary drive and for adding an additional drive. This manual provides instructions for installing an additional drive. If you are also going to replace the primary drive, you may wish to review this manual and manual C1606M before proceeding with the installation to avoid duplication of procedures.
OPEN THE UNIT CHASSIS
WARNING: The chassis assembly includes parts with sharp edges. To avoid injury, use caution when working in and around the DX8000Õs chassis and components.
1.If the DX8000 is mounted in a rack, remove it and transport it to an area that will provide full access to the unit chassis:
a.Disconnect any cables or connections that might restrict access to or the removal of the unit.
b.Unscrew the fasteners that are securing the unit in the rack.
c.Carefully lift the unit out of the rack.
NOTE: Removing the DX8000 from a rack may require more than one person. Refer to the DX8000
Installation Manual for rack mounting information.
2.Place the DX8000 on a flat surface with ample workspace.
C1607M (6/04) | 5 |
