Pelco dx8100 manual Installing The Scsi Card

2.Move the main capture card (refer to Figure 5):

a.Remove the capture card from slot 2 and firmly seat the capture card in the PCI connector for slot 3.

b.Secure the capture card bracket with the screw.

c.Reconnect the 5-wire TV/Audio cable.

d.Reconnect the 7-wire TV/Audio cable.

e.Reconnect the 2-wire audio cable.

NOTE: You will reattach the 32-pin ribbon cable after you install the SCSI card.

Figure 5. Moving the Main Capture Card

INSTALLING THE SCSI CARD

To install the DX8100-ISCI SCSI card:

1.Make sure the main capture card is installed in slot 3. Refer to Moving the Main Capture Card on page 12.

2.Install the SCSI card into slot 2 (refer to Figure 6):

a.Firmly seat the DX8100-ISCI SCSI card in the PCI connector for slot 2.

b.Secure the DX8100-ISCI SCSI card bracket with the screw removed from slot 3.

c.Reconnect the 32-pin ribbon cable to the first 32-pin connector (on the main capture card) in slot 3.

3.Replace the rear cross-brace.

Figure 6. Installing the SCSI Card

C3648M (7/08) 13