DX8100-ISCI SCSI Card Installation
NOTE: When ordered together, the DX8100 and DX8100HDDI units come preconfigured from the factory. The
If you are upgrading an existing DX8100 System, perform the following steps.
PREPARING THE SCSI CARD FOR INSTALLATION
1.Unpack the
2.Verify that you have all the necessary components and tools (refer to Parts List and Tools on page 7).
3.Shut down the unit. Refer to the DX8100 Installation manual (C2629M), Operation/Configuration manual (C2630M), or DX8100 server online Help.
4.Unplug the power cord from the wall socket.
WARNING: It is critical that the unit be unplugged for your safety. You must remove the power cord first because current continues to flow through the DX8100 even when the unit is turned off. Unplug the power cord from the wall socket, then unplug it from the rear of the DVR.
5. Then, remove the power cord from the back of the DX8100.
Figure 1. Removing the Power Cord
6.Disconnect any cables or connections that may restrict access or interfere with the removal of the unit.
7.If mounted in a rack, unscrew the fasteners that secure the unit in the rack and carefully lift the unit out of the rack. Two people may be required for this step.
8.Place the DX8100 on a flat surface with ample workspace. Make sure the area provides full access to the unit’s internal components.
C3648M (7/08) | 9 |
