Pelco DX9100 - page 48

48 C634M-D (12/04)
GATEWAY CONFIGURATION SETTINGS
You must set up the events on the Event Notification page. In case of failure, these settings will send a default error message
to the viewstation, regardless if the Raid Manager application is open or closed.
In the NetSend Setting page, you must enter the IP addresses of all viewstations on the network.
Event Notification
1. Select Setting on the Raid Manager Configuration Window. The Event Notification page appears.
Figure 62. Event Notification Page
2. Make sure the “Add Events to EventLog” checkbox is selected. This is the default setting.
3. Make sure all checkboxes in the “Event Notify in case of” section are selected. This is the default setting.
4. Click OK.