Pelco IS110 SW1-8 Day/Night Operation DW models only, Dark ON, Dusk OFF, Color to B-W, 1.0 lux

SW1-8: Day/Night Operation (DW models only)

NOTE: On CW models, SW1-8 is unused and does not affect camera operation.

DW model cameras regularly check the brightness level of the field of view to determine when to switch between day (color) and night (black-white) operation. Use SW1-8 to set the general light levels at which the camera will automatically switch.

Set SW1-8 to ON (dark) to use standard thresholds to switch between color and black-white operation. This is the default setting.

Set it to OFF (dusk) to use higher light thresholds to switch between color and black-white operation.

Actual brightness threshold levels are affected by camera angle, amount of zoom, field of view, lens, and type of lighting. The switching process lasts from 7 to 10 seconds.

NOTE: If the camera switches between day/night mode at least three consecutive times within a short time period, the camera will remain in the last mode for 10 minutes. To override this 10-minute pause, cycle the power or expose the camera to an extreme light level change (for example, from very dim light to very bright light).

Figure 14 and Table H show how the camera switches between color and black-white operation for each setting.

B-WCOLOR

COLOR

MODE

B-WCOLOR

MODEMODE

MODEMODE

7.0 lux

FALLING LIGHT LEVEL

B-WCOLOR

MODEMODE

RISING LIGHT LEVEL

FALLING LIGHT LEVEL

4.0 lux

MODE

RISING LIGHT LEVEL

3.0 lux

B-W

1.0 lux

DARK

DUSK

Figure 14. DW Models Threshold Switching Levels

Table H. DW Models Approximate Switching Thresholds

	Dark (ON)	Dusk (OFF)
Color to B-W	1.0 lux	4.0 lux
B-W to Color	3.0 lux	7.0 lux

NOTE: These switching thresholds are approximate and were measured using a 3.0 to 9.5 mm lens at f/1.0. Use the thresholds in Table H as a guide when installing the unit.

C3426M-E (3/09) 27