Pelco IS110 manual Side Conduit Installation

SIDE CONDUIT INSTALLATION

NOTE: You should install the camera module into the back box before installing the back box into the cover. When installing the back box into the cover, rotate the camera module to access the mounting holes (refer to Camera Module on page 16 for more information).

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the cover from the back box.

2.Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware when installing the system outdoors.

3.Remove the conduit plug from the side of the back box.

4.Use a blunt tool to pull the wires and plug, located on the base of the back box, into the back box.

5.Insert the black plug (supplied) into the hole in the base of the back box.

6.Reinstall the back box inside the cover. Align the conduit plug with the notch on the side of the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

7.Install a 0.75-inch (1.91 cm) threaded conduit connector (not supplied) into the conduit hole in the back box.

COVER

0.75-INCH CONDUIT CONNECTOR

BACK BOX

REMOVE

CONDUIT PLUG

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 5. Side Conduit Installation

14 C3426M-E (3/09)