Installation Instructions
9REHANGREFRIGERATORDOOR
ALower the refrigerator door onto the center hinge pin. Ensure that the plastic hinge pin thimble is on the center hinge pin or inside door hinge pin hole located in the bottom of the door.
BInsert the door thimble into the hinge hole on top of the refrigerator door and then insert the top hinge pin. Make sure the door is aligned with the cabinet . Attach the hinge to the top of the cabinet loosely with the bolts.
CMake sure the gasket on the door is flush against the cabinet and is not folded. Support the door on the handle side and make sure the door is straight and the gap between the doors is even across the front. While holding the door in place, tighten the top hinge bolts. Replace the hinge cover.
10INSTALL THE LOGO BADGE
Remove the adhesive backing paper
and align the pins on the back of the badge with the holes in the door. Apply pressure to the badge to ensure it sticks to the door.
REMOVINGTHEDOORS
(Double Door Refrigerator Models only)
IMPORTANT NOTES
NOTE: Door swing is not reversible.
•Read the instructions all the way through before starting.
•Handle parts carefully to avoid scratching paint .
•Set screws down by their related parts to avoid using them in the wrong places.
•Provide a
IMPORTANT: Once you begin, do not move the cabinet .
These instructions are for removing the doors.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy compartment.
TOOLS YOU WILL NEED
| 3/8″ and 10 mm Socket | |
Adjustable Wrench | ||
Ratchet/Driver | ||
| ||
|
Masking Tape | |
|
|
Phillips Screwdriver
25