6.Attach the back box leash to the lower dome by sliding the leash through the tab of the lower dome until it snaps into place.
7.Configure DIP switches SW1 and SW2 located on the top of the dome drive. For DIP switch settings, refer to the labels located on the top of the dome drive or to the Switch Settings section.
NOTE: When connecting more than one Spectra® dome to a single controller, terminate the unit farthest from the controller. To terminate the dome drive set the
8.Install the dome drive. Refer to Table D for a list of compatible dome drives and back boxes. Line up the blue and red tabs with the blue and red arrows on the hinged door inside the back box. Push in on the tabs. Insert one side and then the other side. Continue pushing on the ends of the tabs until both sides click into place.
Table D. Spectra Dome Drive and Back Box Compatibility
Dome Drive |
| Back Box |
|
| Spectra II | Spectra III | Spectra IV |
|
|
|
|
Spectra II® | • |
|
|
Spectra III™ | • | • | • |
|
|
|
|
Spectra IV | • | • | • |
|
|
|
|
9.Install the lower dome. Align the tabs on the sides of the lower dome with the slots located on the sides of the back box. Snap the lower dome into place.
To use your dome, refer to the operation and programming manual.
7 |
