Pelco NSM5200 Appendices

C3683M (3/09) 29

Appendices

You can increase the video storage capacity of the NSM5200 by adding one or more DAS5200 direct attached storage (DAS). Each DAS5200 adds

up to 12.0 TB of total capacity (up to 9.08 TB of video storage). You can add up to seven DAS5200 units to expand the total capacity for each

NSM5200 up to 81 TB of total capacity (up to 72.6 TB of video storage).

NOTES:

• You do not have to shut down the NSM5200 to add a DAS5200.

• The NSM5200 has one mini-SAS connector on the rear panel; the DAS5200 has two mini-SAS connectors on the rear panel.

• A maximum of seven DAS5200s can be connected (daisy-chained) to a single NSM5200.

To connect one or more DAS5200s to an NSM5200:

NOTE: A rack setup is used in the following configuration.

1. Install the NSM5200 and the DAS5200 (one or more) into a rack system.

2. Connect a mini-SAS cable to the SAS connector on the rear panel of the NSM5200.

3. Connect the other end of the mini-SAS cable to the top SAS connector (IN) on the rear panel of the DAS5200.

4. For each additional DAS5200:

a. Connect the mini-SAS cable to the bottom SAS connector (OUT) on the rear panel of the DAS5200.

b. Connect the other end of the mini-SAS cable to the top SAS connector (IN) on the rear panel of the next DAS5200.

Figure 21. DAS5200s Connected to an NSM5200

Figure 21 displays an NSM5200 with three DAS5200s connected. The configuration is a daisy-chain setup.

5. Power up the DAS5200, if necessary. Refer to the DAS5200 Series Installation manual for more information.

6. Power up the NSM5200, if necessary (refer to Unit Startup on page 25).

The NSM5200 automatically recognizes the new DAS5200 unit within five minutes, and then puts it into service.

MINI-SAS CABLE

DAS5200

NSM5200

ENDURA NETWORK