18 Pelco Manual C2419M-A (5/00)
PARK TIME MINUTES
This feature causes the dome to park at preset 1 after a programmed number of minutes of
control inactivity. The time can be set from 1 minute to 720 minutes (12 hours), or it can be set
to zero, which disables this feature.
To change the park time:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Park Time Minutes.
5. Press the Iris Open button. The cursor moves to the right, beside the current park time.
6. Move the joystick up or down to change the park time.
7. SELECT - Press the Iris Open button on your keyboard to select your choice.
CANCEL - Press the Iris Close button if you do not want to change the setting.
NOTE:

Preset 1 must be

programmed for the dome to

park.

Main Menu
<Camera>
<Line Sync>
<Power Up>
<Aux>
<Alarms, Zone Blank>
<Other>
EXIT
Other Menu
Auto flip On
Proportional pan On
Limit stops On
Park time minutes 0
Scan speed deg/s 25
Pattern length 6 min
Exit
LOWLIGHT LIMIT (Color Camera Only)
NOTE:

Auto focus is auto-

matically turned off when

the shutter time is longer

than 1/8 of a second.

NOTE:

LOWLIGHT does

not mean NO LIGHT. Some

type of illumination is

required (street light, IR

light, etc.)

This setting determines the maximum length of time the shutter will remain open automatically
in low light conditions. There are six choices:
2 = 1/2 second 8 = 1/8 second 30 = 1/30 second
4 = 1/4 second 15 = 1/15 second 60 = 1/60 second
To change the LowLight setting:
1. On the main menu, move the joystick up or down to position the cursor (>) beside Camera.
2. Press the Iris Open button to enter the Camera menu.
3. Position the cursor (>) beside Next.
4. Press the Iris Open button to go to the Next menu.
5. Position the cursor (>) beside LowLight limit.
6. Press the Iris Open button. The cursor moves to the right, beside the current LowLight limit.
7. Move the joystick up or down to choose the LowLight limit.
8. SELECT – Press the Iris Open button to select your choice.
CANCEL – Press the Iris Close button if you do not want to change the setting.
Main Menu
<Camera>
<Line Sync>
<Power Up>
<Aux>
<Alarms, Zone Blank>
<Other>
EXIT
Camera Menu
Backlight comp Off
Zoom limit x- -
Reset camera
<Gain/AGC>
<Auto-iris>
<Next>
Exit
Next Menu
LowLight limit 2
Shutter speed Auto
Auto focus mode Auto
<Sharpness>
<White balance>
Prev (back to prev. menu)
Exit