Pelco Spectra IV SE manual Switch Settings

Switch Settings

WARNING: If you are using D-type or P-type control, your system may not operate if the baud rate and address switches are not set correctly. The switches are set at the factory at the defaults for D-type control (2400 baud and address 1).

Table E. Switch Settings for SW2

Special Systems
Switch Number	1	2	3	4	5	6	7	8	9	10
AD-32 Preset System	ON
CM9502 Setting		ON
Vicon		Not currently available; SW2-3 is reserved for future use.
Serial Port Settings
Switch Number	1	2	3	4	5	6	7	8	9	10
RS422				OFF	OFF
RS485, Four Wire				OFF	ON
RS485, Two Wire				ON	ON
D or P Protocol Baud Rate
Switch Number	1	2	3	4	5	6	7	8	9	10
2400 Baud (Default for D-type Control)						OFF	OFF	OFF
4800 Baud (Default for P-type Control)						ON	OFF	OFF
9600 Baud						OFF	ON	OFF
Video Cable Type
Switch Number	1	2	3	4	5	6	7	8	9	10
Coax Cable									OFF
UTP Cable									ON
Dome Termination
Switch Number	1	2	3	4	5	6	7	8	9	10
Terminated										ON
Not Terminated										OFF

C3417M-B (11/06) 9