Pelco SS3002 operation manual Ceiling/Wall Mounting, PELCO Manual C428M-B2/98

3.4.1 Ceiling/Wall Mounting

NOTE: The “Schneider” ring referred to in these instructions is a 10-inch black aluminum ring designed to fit around the square portion of the up- per dome. Use of this ring helps to camouflage movement of the dome.

NOTE: Disregard step 3 if using the PT280-24SL pan/tilt.

NOTE: When installing a PT280- 24SL pan/tilt with the slip ring option you will need to remove one (1) of the 1/4-20 fasteners holding the mount- ing flange to the SL2800 bracket. Pivot the pan/tilt assembly to one side to allow the connector and cable to pass through. After the connection is made, pull the connector back up into the pipe and reattach the mounting flange.

NOTE: When mounting a long cam- era/lens assembly (13" to 15") into a SS3000 enclosure, it must be mounted to the pan/tilt backwards so the lens is to the rear of the pan/tilt. This is to allow full downward tilt of the long lens. This must also be taken into consideration when wiring the unit, as the motions will be reversed.

NOTE: The small hole in the upper dome (for safety chain attachment) should be positioned at the back (con- nector) end of the camera.

1.Select an appropriate length of 1-1/2" NPT pipe for the mount you have se- lected. Once the mount is installed, insert and tighten the pipe to approxi- mately 30 ft lb, then tighten the 8-32 screw in the pipe nut to lock the pipe threads. Slide the black 10"OD “Schneider” ring over the pipe and then slide the upper dome onto the pipe and lock it out of the way with a suitable retainer.

2.Screw the mounting flange (item 4, Figure 5) onto the pipe and tighten to approximately 20 ft lb. Tighten the 8-32 screw in the pipe nut to lock the pipe threads (refer to Figure 4).

3.Align the three-hole pattern in the pan spindle (PT280-24P) with the holes in the lower bracket (item 5, Figure 5) and attach with 1/4-20 x 5/8" hex head bolts and lock washers provided. Tighten firmly.

4.Assemble the lower bracket and pan/tilt to the mounting flange (item 4, Figure 5) using 1/4" x 5/8" hex head bolts, flat washers, and hex nuts provided.

5.Attach the upper (drive) bracket (item 3) to the bottom (spindle side) of the pan/tilt using four (4) 10-32 x 1/2" pan head screws and lock washers pro- vided. Refer to Figure 5 for proper orientation.

6.Feed the main cable from the control or receiver through the center of the 1-1/2" pipe and connect it to the cable of the pan/tilt. Pull the cable and con- nector back up into the pipe so that it does not get caught on the rotating parts.

7.Install the camera/lens assembly onto the tilt table of the pan/tilt. Connect the proper cables (camera, lens function).

8.Remove the retainers from the upper dome and lower it until it seats itself on the upper (drive) bracket.

Figure 4. Locking the Pipe Nut

PELCO Manual C428M-B (2/98) 9