C1309M-A (9/08) 7
Setup
Before configuring the camera settings or installing the unit, you must remove the camera assembly from the enclosure to set up the basic wirin g
configurations (refer to Bench Setup on page9).
The camera can either be configured on a bench using a PC in a lab environment, or using a laptop in the field. The setup instructions vary slightly
depending upon the type of configuration you choose.
Figure 1. Exploded View of TI2500 Series Thermal Imager
WARNINGS:
• During setup, keep the lens cover on the camera to avoid scratching the lens.
• Do not expose the camera to direct sun for extended periods without the sun shield installed.
ìBack Plate
îEnclosure and Sun Shield
ïCamera Assembly
ñGround Stud
óCable Gland
r“T” Handle
sVideo Cable
tShielded Power Cable and Shielded Serial Cable