Pelco Manual C651M (7/99) 13
Figure 1. Typical System Setup
AUDIO
OUT
MIC IN
VIDEO OUTPUT
FROM CAMERA
VIDEO IN
AUDIO IN
MONITOR
VIDEO
OUT
CCTV
CAMERA
VIDEO
IN
MIC
600 Ω
VIDEO OUTIN
IN OUTMIC AUDIO
RESET
REMOTE
SETRST
IN
RECGND ALMMODE CLK CALL
OUT
AUDIO IN
ALARM OUTPUT
FROM DEVICE
SET
IN
ALARM DEVICE
4. If you are not using a switcher, refer to Figure 1.
• Connect the camera (video output) to the rear of the VCR (video input
BNC). Connect the VCR (video output BNC) to the monitor (video input).
• Connect the alarm input to the VCR (SET IN and GND [ground] terminals).
• If you are using a 600 Ω microphone, connect it to the VCR (MIC IN jack).
Connect the VCR (audio output connector) to the monitor (audio input).
5. If you are using a switcher, refer to Section 4.3.