Pelco Manual C672M (2/01) 23

5. MIC jack
Jack for connecting a microphone rated at 600 ohms impedance.
6. AUDIO IN connector
Audio input connector (RCA pin).
7. AUDIO OUT connector
Audio output connector (RCA pin).
8. VIDEO IN connector
Input connector for video signal (BNC connector). Connect cameras here.
9. VIDEO OUT connector
Output connector for video signal (BNC connector). Connect a monitor here.
10. RESET button
Press to erase the date, present time, alarm recording list, power loss list, and the
number of tape uses; and reset them to their default values. Power to the VCR is cut
off while the button is pressed. If there is a tape in the VCR and the button is released,
the power indicator lights and the tape fast forwards for a few seconds. The VCR then
turns off.
11. RS-232C terminal (DB9)
Input terminal for connecting a PC using an RS-232C crossed cable.
USING THE JOG AND SHUTTLE CONTROLS AND ADJUSTINGTHE CLOCK

JOG AND SHUTTLE CONTROLS

00388
JOG/ADJUS SHUTTLE
CLEAR/
REW
ENTER/
FW
MENU
/
TIME DATE
PLAY/
REC CHECK
COUNTER
RESET
PAUSE/
SUTTLE HOLD
STOP
SEARCH TIMER REC
SHUTTLE RING
JOG DIAL

Figure 12. JOG Dial and SHUTTLE Ring

USING THE JOG DIAL

•Turn by using your finger on the indent.
•Turning the JOG dial right advances you through the options while turning left
reverses direction.
• When the option is not flashing, turn right to move the cursor downward; turn left to
move upward.

USING THE SHUTTLE RING

•The SHUTTLE ring automatically centers itself if you turn it fully right/left and release
it.
•Some menus move down to the next layer when you turn the SHUTTLE ring right.
Turning it left returns to the previous layer.