C656M-E (4/07) 9
Figure 5. Fastening the Esprit Cover
10. Remove the pan and tilt from the base of the Esprit system.
11. Check the control wiring inside the base of the unit. Refer to the Esprit documentation and the
documentation supplied with your controller to make sure the wiring is correct.
12. Reattach the pan and tilt onto the base of the unit.
13. Apply power to the system. The following message appears on the monitor as soon as the Esprit
configuration cycle is completed:
TXB-V REV x.xx
NOTE: x.xx represents the current firmware revision.
Vicon Controller
Terminal Block J1
Esprit
Wire Harness
Pin 9 Response Out + White (TX+)
Pin 8 Response Out - Black (TX-)
Pin 3 Command In + Red (RX+)
Pin 2 Command In - Green (RX-)
TOP GASKET
FRONT
RAIN
GUARD