Samsung HTDB390RH/ELS manual Connecting Wireless Rear Speakers, Connect your pair

press the POWER button in Standby mode.

Connecting Wireless Rear Speakers

1 Connect your pair of	2 Insert the power plug into an outlet,
wireless rear speakers,	and then press the POWER button
(L) and (R), to the	on the front panel.
wireless rear amplifier.	•	The Power Standby indicator will light up.
	•	To turn off the wireless rear amplifier,

Wireless Rear Speaker (L) Wireless Rear Speaker (R)

Back of Wireless Rear Amplifier

Caution

•Do not connect the wireless rear speakers to the speaker outputs on the back of the main unit. Malfunction may result.

•The wireless receiving antenna is built into the wireless rear amplifier.

Keep the unit away from water and moisture.

•For optimal listening performance, make sure that the area around the proposed wireless rear amplifier location is clear of any obstructions.

Connecting the Wireless Transmission Antenna to the Main Unit

1 Connect the wireless	2 Raise the wireless
transmission antenna to	transmission antenna a
the back of the main unit	full 90 degrees.
and tighten the nut by
hand.

Caution

•Do not apply a strong shock to the wireless transmission antenna. Breakage may result.

•Do not touch the wireless transmission antenna during operation. Noise or interference to communications may result.

Note

• Place the wireless rear amplifier at the rear of the listening position. If the wireless rear amplifier is too close to the main unit, some sound interruption may be heard due to interference.

•If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.

•The transmission distance of radio wave is about 33 feet but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the main unit and the wireless rear amplifier, the system may not operate at all because the radio wave

13 cannot penetrate metal.