INSTALLING ROTO COVER AND CRANK
Note: Finish the interior of the window and allow the window to dry before proceeding with these instructions. (To open the window for finishing, partially insert the lock handle into the jamb, unlock the unit, temporarily attach the crank handle and turn to open.)
A.Place the cover over the operator stud and snap into place. Position the pocket end of the cover into place.
Note: If the cover does not have the screw hole, apply pressure on the pocket end of the cover to snap the cover into place and proceed to step C.
B.Insert the provided screw into the hole in the bottom of the pocket. Use a # 1 Phillips screwdriver to secure the pocket screw snug against the bottom of the pocket to avoid scratching the crank handle knob. DO NOT over tighten.
C.Use a medium size
D.Slide the crank handle onto the stud. Unlock, open window, then close and lock window.
E.Fold the crank handle down and check alignment of knob with the pocket.
Note: You may need to adjust the crank position on the stud until the correct alignment is achieved.
F.Open the crank and tighten the set screw.
G.After the final installation, fold the crank over and snap the knob into the pocket.
Pocket End |
Screw Hole |
Operator Stud |
A |
B |
Crank Handle | D |
|
Operator Stud |
|
|
Set Screw | C | |
Knob |
| E |
Note: Even with the window open the crank can be folded to avoid interferring with the window treatments.
