20
IntelliFlo 4 Installation and User’s Guide
Pump Disassembly (Continued)
9. To unscrew the impeller from the
shaft, twist the impeller
counterclockwise.
10. Remove the rotating portion of the
mechanical seal from the impeller.
11. Remove the four bolts from the
seal plate to the motor, using a
9/16 inch wrench.
12. Place the seal plate face down on
a flat surface and tap out the
carbon spring seat.
13. Clean the seal plate, seal housing,
and the motor shaft.
Pump Reassembly/Seal Replacement
1. When installing the replacement shaft seal, use silicone sealant on the metal portion before pressing
into the seal plate as shown.
2. Before installing the rotating portion of the seal into the impeller, be sure the impeller is clean. Use a
light density soap and water to lubricate the inside of the seal. Press the seal into the impeller with
your thumbs and wipe off the ceramic and carbon faces with a clean cloth.
3. Remount the seal plate to the motor.
4. Grease the motor shaft thread and screw impeller onto the motor shaft.
5. Screw in the impeller lock screw (counterclockwise to tighten).
6. Remount the diffuser onto the seal plate. Make sure the plastic pins and holding screw inserts are
aligned.
7. Grease the diffuser o-ring and seal plate gasket prior to reassembly.
8. Grease the bolt threads, assemble the motor subassembly to the strainer pot-pump body by using the
two (2) through bolts for proper alignment. Do not tighten the through bolts until all six (6) bolts are
in place and finger tightened.
9. Reconnect the RS-485 communication cable to the pump.
10. Fill the pump with water.
11. Reinstall the pump lid and plastic clamp, see page 14 for details.
12. Prime the pump, see page 8.
Shaft Seal Replacement
The Shaft Seal consists primarily of two parts, a rotating member and a ceramic seal. The pump requires
little or no service other than reasonable care, however, a shaft seal may occasionally become damaged and
must be replaced.
Note: The polished and lapped faces of the seal could be damaged if not handled with care.
LOCK SCREW SEAL
LOCK SCREW
SEAL
O-RING
SET SCREW
MOTOR
BOLT (4x)
MOTOR
BOLT (2x)
GASKET
SEAL PLATEIMPELLER