4
Section 1: Installing a mounting bracket and light fixture during new vinyl pool construction (Continued)
d. The mounting bracket and mounting hub must be properly installed so that the top edge of the face ring of the Nicheless Light is at least 18 inches below the surface of the water in the pool. The top of the face ring will line up with the center of the Plastic Mounting Hub, see Figure 1 on page 3.
e. The mounting bracket (not shown) and mounting hub must be properly electrically bonded and grounded via the No. 8 AWG ground connector located at the upper left mounting bolt positioned, see Figure 2.
2. To be certain that the pool's electrical system meets all applicable requirements, you should also consult the local
13
Vinyl Liner Mounting Bracket Parts
Patent Number 5,051,875
Models 250 watt / 120 volt and
100 watt / 12 volt (transformer required)
(
&
)
building department.
3. Use only Pentair Nicheless Fixtures, (Mounting Bracket Assembly), to ensure proper bonding and grounding connections.
Figure 2
B. Perform the following steps after the electrical system requirements are met (see Section 1A (page 3) for requirements)
1. Locate position on a vertical wall where light is to be installed. The top of the light face ring must be 18 inches below normal water level as required by NEC Article 680.
2. Cut or punch a three (3) inch diameter hole through pool wall with center 18 inches below normal water level for mounting hub and mounting bracket installation.
3. If using plastic conduit, install PVC conduit adapter (provided) before installing plastic mounting hub. Use only recommended sealant for PVC/ABS threads. Position mounting hub over hole with the word “TOP” at the top, and secure with mounting flange and two (2) hex nuts and lock washers. Tighten hex nuts evenly with equal torque.
NOTE: Attach the stainless steel mounting bracket temporarily to ABS mounting hub. Perfect top and bottom alignment of ABS hub will be easier.
CAUTION: Remove mounting bracket before liner is installed. Failure to remove mounting bracket can damage the liner during installation.
| Vinyl Liner Replacement Parts |
|
|
| Part |
Item | Number Description |
1619547 Wall mounting bracket assembly
2619548 Metal bracket cup assembly
3 619549 | Mounting hub 3/4 in. assembly |
4619550 Mounting hub 1 in. assembly
578872600 Mounting spacer
6619617 Housing spacer
786001800 Nipple, 1 in.
AquaLumin® II - Nicheless Light Installation Guide | AquaLumin® II - Nicheless Light Installation Guide |
