TEMPERATURE CONTROL :
Separate electronic controls are provided for POOL and SPA heating. Each control incorporates the following :
THERMOSTAT Dial :
Used to preset your desired water temperature.
As long as the Heat Select Switch is not in the "OFF'position, the water will heat up to the preset temperature whenever the filter pump is running.
Heat Select Switch :
It is possible to heat your spa and swimming pool using solar energy, conventional heat, or a combination of both. However, no heating will take place unless the filter pump is running:
SOLAR Position: | Allows heating with solar only. |
S.PREF Position: | Allows preferential heating with solar, but automatically switches to |
| conventional heating when solar energy is unavailable. |
HEATER Position: Allows heating with gas or electric heater only. | |
| Note: If you are heating the swimming pool (and also the spa in some |
| custom applications), the solar system may also contribute to the |
| conventional heat whenever solar energy is available. |
OFF Position: | Allows no heating. |
WATER TEMPERATURE Display :
Whenever the filter pump is running, the precise water temperature will be displayed in degrees Fahrenheit.
Pool temperature will be displayed during pool circulation, and spa temperature displayed during spa circulation.
Note: Filter pump must be running in order to provide accurate temperature display.
VALVE OPERATORS
Your control system is designed to actuate two motorized valves, which automatically rotate between pool and spa filtration whenever the SPA Button at the
A motorized valve may also be used to automatically divert the flow of water through your solar panels whenever solar energy is available.
These Valve Operators are also activated by the FLOW CONTROL and SOLAR CONTROL Switches at the
Your system may also include additional motorized valves for custom hydraulic applications, such as a fountain or waterfall, or (in lieu of a booster pump) to activate your pool cleaner.
SINGLE OCCURRENCE PROGRAM :
Occasionally, you may w~shto use your spa at a time which is different from your normal daily program.
In this instance, it is poss~bleto enter a "once only" program step which will occur within the following 24 hour period without having to reprogram the daily equipment sequence. The "once only" program will automatically be canceled once the Clock reaches its next
program step. | I | + |
Push PROGRAM Button to put the Clock into |
| TIME CONTROL |
Program Mode. |
|
|
"PROG" will appear on the right of the Display. |
|
|
Continue to push PROGRAM Button until a |
|
|
flashing "ONCE'appears. |
|
|
Enter the time that you wish to activate the spa |
| Mill O U R SPA AUXI |
(11:00 pm in our example) by pushing HOURS |
| |
|
| |
and MINUTES Buttons. |
|
|
Push SPA Equipment Button. |
|
|
"ON" will appear directly above the SPA and | \ | I |
|
|
FILTER Buttons.
Push P R O G W Button to
Remember to manually turn off the spa after use, otherwise it may run all night until the Clock reaches its next program step.
EIGHT PROGRAM STEPS :
If the standard six program steps are insufficient for your particular programming requirements, it is possible to modify the Clock so that eight program steps may be entered.
Consult the Installation Manual for details.
TROUBLE-SHOOTING
GENERAL :
1.Check all circuit breakers at the electrical supply panel.
2.At the
NOTHING OPERATES :
1.Check 3 amp circuit breaker which is located above faceplate in
2.If circuit breaker continues to trip, refer to a qualified Service Company.
3.At the
If the equipment can now be operated, there may be malfunction at your
