General Safety / Assembly

3

14.Protect electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking cord. Replace or repair damaged or worn cords immediately.

15.Do not touch an operating motor. Modern motors are designed to operate at high temperatures.

Risk of electric shock. If your basement has water or moisture on the floor, do not walk on wet area until all power has been turned off. If shut-off box is in basement, call electric company or hydro authority to shut-off service to house, or call your local fire department for instructions. Remove and replace system. Failure to fol- low this warning can result in fatal electrical shock.

Risk of electric shock. Do not handle pump or pump motor with wet hands or when standing on wet or damp surface, or in water. Always disconnect the pump and switch from the electrical power source before doing any maintenance.

16. Pump water only with this pump.

ASSEMBLY

Steps 1 and 2 (See Figure 1)

Step 4 (See Figure 3)

Install the discharge pipe hand-tight plus one-half turn.

4

Figure 3

Step 5 (See Figure 4)

Place the pump in the basin as shown. Align the discharge with one of the threaded ports in the cover.

112" NPT 112" NPT

Discharge Vent

2

Inlet

Pump

Basin

Figure 1

Step 3 (See Figure 2)

3

Figure 4

Step 6 (See Figure 5)

Turn the cover upside down and ‘lay in’ the basin gasket as shown.

Locating

Cleats

Figure 2

Figure 5

 

Page 3
Image 3
Pentair DP233110V owner manual General Safety / Assembly