Pentair DP233110V owner manual Assembly / Installation, Installation See Figure

Assembly / Installation 4

IMPORTANT: To prevent leaks, be sure that the cleats on the corners of the basin gasket are up with the cover upside down (that is, not pressed into the sealing face of the cover).

Step 7 (See Figure 5)

Push the screws with their washers installed up through the holes in the rim of the cover and in the basin gasket (the cover will retain the screws).

Step 8 (See Figure 6)

•Align the cover with the discharge pipe and cords.

•Pull the cords through the non-threaded hole in the basin cover.

•Place the cover over the discharge pipe.

•Install the cords in the cord grommet

•Install the cord/grommet assembly in the non-threaded hole in the basin cover; don’t pull the cords tight.

112" NPT

Discharge

112" NPT Vent

Cord Grommet

Inlet

Discharge

Pump

4720 1004

Figure 6

Step 9 (See Figure 6)

Fasten the basin cover to the basin with the capscrews previously inserted in the cover (Step 7).

IMPORTANT: To prevent leaks, be sure the locating cleats on the corners of the basin gasket are outside the edges of the basin rim, not pressing against the rim.

INSTALLATION (See Figure 7)

The basin (system) should be located at the lowest place possible relative to the area to be drained.

NOTE: Make sure that the inlet of the pre-plumbed system is lower than the water to be pumped.

Thread pipes into fittings; don't go past end of threads.

112" NPT	112" NPT
Vent	Discharge

151/8"

112" NPT Inlet

	133/4"
1/3 HP	12"
Pump
	Vertical Float Switch
	12"

Figure 7 – Sink Pump System Dimensions

1.Install inlet pipe in opening as shown. Use RTV sealants or Plasto-Joint Stik* to seal threads. See Figures 8, 9, and 10, page 4 and 5, for typical installation arrangements.

Discharge

Vent

Pump

Figure 8 – Typical installation to remove air conditioner condensate or dehumidifier water

*Lake Chemical Co., Chicago, Illinois