III. Operation/Periodic Maintenance
A.Connecting/Disconnecting the Legend® II
Turn off pool pump. Then take the Wall Fitting and twist lock the Wall Fitting clockwise into the Wall Adapter. To disconnect the Legend® II, unlock and twist counter clockwise. The Wall Adapter should remain in the pool wall.
B. Turning On/Off the Legend® II
The Legend® II operates off a filtration pump coming from the equipment pad, and can be turned on or off by merely turning on/off your pump time clock.
C. Cleaning the Sand & Silt Bag
Carefully unlock the debris bag from the vacuum tube and open the Velcro® Brand fastener at the top of debris bag and dump debris.
If you have a lot of debris in your pool, especially after a storm, you can run your Legend® II in two shorter cycles per day and empty the debris bag between cycles.
Reconnect the debris bag to the vacuum tube. Do NOT over turn.
If the Velcro® Brand fastener on top of the debris bag does not stay secure, rinse well, let it dry and clean with a stiff brush.
A Helpful Hint: It is easier to empty the debris bag when it is dry. A second bag may be used while the full debris bag is drying.
It's best to empty the debris bag when it becomes half full. The Legend® II will have better performance if the bag is not overloaded.
D. Periodic Maintenance
The following parts are wear items that should be checked, maintained or replaced as needed. Wear items are considered any working or moving part(s) being worn due to the use of the cleaner. Wear items are not covered under warranty.
1. Wall Fitting Screen
Inside the wall fitting is a filter screen that acts as a secondary filter. This screen is to keep debris that is passed by the pool filter out of the Legend® II. Running the Cleaner without the filter screen can damage the Legend® II and will void the warranty.
A continuous plugged or dirty screen is a sign of problems in your pool filtration system and you need to contact your local pool professional.
To clean the filter screen, pull the screen out from inside the Wall Fitting and rinse thoroughly and push back inside the wall fitting.
Whenever cleaning, back washing or repairing filter, remove the wall fitting and flush out the dedicated line before using the Legend® II.
7
LEGEND® II INSTALLATION MANUAL
