Slide the setting switch back up to the (whitedot).

When you turn the camera on and press the shutter release button halfway down, the channel of the flash unit is registered on the camera.

(Preparation of Separated Flash Unit)

2 Next, set the channel of the separated (wireless) flash unit to the same channel as the flash unit attached to the camera.

Place the other AF540FGZ in the desired

position.

Set the power switch of the flash unit to (WIRELESS).

Press the wireless mode button (M/C/S) the number of times required to display SLAVE on the LCD panel.

Slide down the setting switch to the (yellow

dot) to display the channel on the LCD panel.

Press the channel button (CH) and select the same channel that the flash unit attached to

the camera has been set to.

Slide the setting switch back up to the (white dot).

●The two flash units must be set to the same channel, otherwise the separated flash unit will not fire.

(Photographing)

3 Confirm that both flash units are fully charged, and take the photograph.

A lamp on the wireless flash unit will blink.

45