Confirm that both flash units are fully charged, and take the photograph.
A lamp on the wireless flash unit will blink.

Slide the setting switch back up to the (white

dot).

When you turn the camera on and press the shutter release button halfway down, the channel is registered on the camera.

2 Next, set the channel of the separated (wireless) flash unit to the same channel as the flash unit attached to the camera.

Place the other AF540FGZ in the desired position.

Set the power switch of the flash unit to

(WIRELESS).

Press the wireless mode button (M/C/S) the number of times required to display SLAVE on

the LCD panel.

Slide down the setting switch to the (yellow

dot) to display the channel on the LCD panel.

Press the channel button (CH) and select thesame channel that the flash unit attached to the camera has been set to.

Slide the setting switch back up to the (white dot).

●The two flash units must be set to the same channel, otherwise the separated flash unit will not fire.

3 Set the sync mode switch of the wireless flash

unit to leading curtain sync ().

4 Set the exposure mode of the camera to manual exposure and the shutter speed faster than X- sync speed.

● If the shutter speed is the same or slower than the X-sync speed of the camera, the flash will be set to P-TTL mode, and when it is faster than X- sync speed, the flash will be set to high-speed

5sync mode.

49