TROUBLE SHOOTING

Volkswagen

Make sure you have your radio’s theft protection code before you attempt installation. When you reconnect power to the battery, you will need to enter this code. Information about the theft protection code can be found in your vehicle’s audio operation manual.

Before connecting any cables to the Aux2Car you must set the dip switches to the correct position. If you set the dip-switches after you have connected cables to the interface, you must disconnect and reconnect them for the Aux2Car to operate.

DIP SWITCHES MUST BE SET BEFORE YOU PLUG IN THE Aux2Car !!!

SETTINGS FOR

1

2

3

4

5

6

7

8

ALL VW’S

on

off

off

off

off

off

off

on

 

There are two different cables for Volkswagen vehicles. The PXHVW1 cable is for pre-wired vehicles with the CD Changer connection in the trunk. The PXHVW2 is for direct connection behind the radio.

If you use the PXHVW2 cable make sure you connect the black and white cable to ground

 

If Aux2Car is not being recognized, sound is noisy and/or

 

Keys on radio not properly working please Disconnect the

 

Aux2car adapter from trunk, and plug to radio using VW

 

front cable directly to radio

 

Cause: VW prewired cable to trunk not shielded and is

 

causing noise from Aux2Car datalines, into audio lines

OPERATION

Switch to the Aux2Car adaptor by pressing the “CD” button on

 

the radio.

14

Page 16
Image 16
Peripheral Electronics Aux2Car instruction manual Volkswagen, Settings for