Perle Systems C-110-XXXXX, CM-110-XXXXX manual Installing or Replacing Media Converter Modules

Installing or Replacing Media Converter Modules

Caution: Observe electrostatic discharge precautions when installing the Media Converter Module(s) into the Chassis. Failure to observe this caution could result in damage to the Media Converter Module(s) and /or chassis.

The Perle Media Converter Modules can be installed in any available slot and in any order within the Chassis.

Installing or Replacing a Media Converter Module

1.Remove the Media Converter Module from its packaging.

2.Using a cross-head screwdriver, remove the screw holding the face plate to the Chassis to reveal the slot opening.

3.Set the jumpers and DIP switches on the Media Converter Module to the desired operating mode.

4.Locate the top and bottom alignment guides inside the Chassis.

5.Using the module alignment guides gently slide the module into the slot until it becomes flush with the front of the Chassis. Light pressure may be needed to seat the module. Do not force the module as you might cause some damage. If there is resistance, remove the module, check the module connector for damaged or incorrectly aligned pins, if there is no damage, retry module insertion.

10 Perle 10/100 Media Converter Module – Installation Guide