Perle Systems MDC, SDS manual Set RIP, Show RIP

RIP Commands

Set RIP

Description	Configures the RIP MD5 key. After pressing Enter, you will be prompted for the MD5
User Level	key value.
	Admin
Syntax	set rip [authentication nonepasswordmd5]
	[ethernet-mode nonesendlistensend-and-listen]
	set rip password
	set rip md5 <config_md5_id> [end <date> <time>]
	[start <date> <time>] [key]
Options	authentication

Specify the type of RIP authentication:

zNone—No authentication for RIP.

zPassword—Simple RIP password authentication.

zMD5—Use MD5 RIP authentication.

ethernet-mode

Enable/disable RIP (Routing Information Protocol) mode for the Ethernet interface with one of the following options:

zNone—Disables RIP over the Ethernet interface.

zSend—Sends RIP over the Ethernet interface.

zListen—Listens for RIP over the Ethernet interface.

zSend and Listen—Sends RIP and listens for RIP over the Ethernet interface.

password

When you type the set rip password command and press Enter, you will be prompted to type in a password and then re-enter that password.

<configured_md5_id>

The MD5 identification key.

end <date> <time>

The last day that the MD5 key is valid. Specify as dd/mm/yyyy.

The time that the MD5 key becomes invalid. Specify as hh:mm:[ss].

start <date> <time>

The start date that the MD5 key becomes valid. Specify as dd/mm/yyyy.

The time that the MD5 key becomes valid. Specify as hh:mm:[ss].

key

When you press Enter after typing the key command, you will be prompted to enter the

MD5 key value and then re-enter the key value.

Show RIP

Description	Shows the RIP settings.
User Level	Normal, Admin
Syntax	show rip

Network Commands 113