IPsec Commands
114 IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7

Show RIP Peers

IPsec Commands
Once there is an active VPN tunnel, the IOLAN expects all connections to be established through a
VPN tunnel. To allows hosts to connect outside of the VPN tunnel, you must configure VPN
exceptions, see VPN Exceptions on page 121 for the command syntax.

Add IPsec

Set IPsec

Description Shows current information about IPv4 or IPv6 RIP peers.
User Level Normal, Admin
Syntax show rip peers [ipv6]
Description Adds an IPsec tunnel.
User Level Admin
Syntax add ipsec <tunnel_name>
Option <tunnel_name>
The name of an IPsec VPN tunnel. You can configure up to 64 VPN tunnels.
Description Configures the IPsec tunnel.
User Level Admin
Syntax set ipsec <config_tunnel_name>
[authentication-method shared-secret|rsa-signature|x.509-certificate]
[boot-action start|add|ignore] [local-device left|right]
[local-external-ip-address <IPv4/IPv6_address/FQDN>]
[local-host-network <IPv4_addr> <subnet_mask>|
<IPv6_address> <prefix_bits>]
[local-ip-address <IPv4/IPv6_address/FQDN>]
[local-next-hop <IPv4/IPv6_address>]
[remote-external-ip-address <IPv4/IPv6_address/FQDN>]
[remote-host-network <IPv4_addr> <subnet_mask>|
<IPv6_address> <prefix_bits>]
[remote-ip-address <IPv4/IPv6_address/FQDN>]
[remote-next-hop <IPv4/IPv6_address>]
[remote-validation-criteria
country <code>|state-province <text>|locality <text>
|organisation <text>|organisation-unit <text>
|common-name <text>|email <email_addr>]
set ipsec <config_tunnel_name> secret <text>
set ipsec use-nat-traversal enabled|disabled