Perlick HA24, HH24, HC24, HP24, HP48, HP15 installation manual Handle Installation, the factory door

12). Place the lower V-block into the lower cabinet hinge with the notch parallel to the cabinet (Fig. 15).

V-block parallel

to cabinet

TOP VIEW

Figure 15. Installing V-Block

13). Lift the door assembly and insert the top pin into the bearing. Move door toward cabinet and align the V-blocks (Fig. 16).

Insert top pin

into bearing

Insert and tighten hinge pin

Figure 16. Installing Door

14). Insert and tighten the lower hinge pin to complete the assembly.

PERLICK RESIDENTIAL INSTALLATION MANUAL

HANDLE INSTALLATION

CAUTION The handle mounting on the wood overlay should be mounted on the overlay only (not the actual door) to avoid damage to

the factory door.

1.Handle must be attached to the overlay before mounting the overlay onto the door. Mark the rear of the wood overlay panel with handle fastening locations.

2.Drill through the wood overlay panel at marked locations, taking care not to damage the panel.

3.Countersink screw heads so that screw heads are flush with the back side of the panel. Attach the handle to the overlay panel.

CAUTION Proper woodworking materials and equipment should be used to

avoid damage or errors in workmanship.

DOOR LOCK INSTALLATION

NOTE: Full size lock installation wood overlay panel templates are available on the Perlick website. Visit www.perlick.com/ Residential, click on Service & Support, and then choose Wood Overlay Templates from the menu. Lock templates are available for all HP, HC, HA and HH series models. Take care in choosing the correct template for your specific model.

When installing to a wood overlay, perform the lock installation before mounting the wood overlay to the door!

1.See Figure 17 below. Attach mounting bracket to wood overlay.

2.Insert lock body and attach with nut.

Mounting bracket

Nut

Lock strike

Lockwasher

Lock body

Screw

Lock bracket

Figure 17. Installing Door Lock

perlick.com 11