PERLICK RESIDENTIAL INSTALLATION MANUAL
SHELVING/DRAWER ADJUSTMENTS
CAUTION Completely empty shelf or drawer before removing.
1.Pull the shelf/drawer out to its furthest position. Locate the tabs in the middle of both extenders. Lift one tab up while pushing the opposite tab down, and pull shelf/ drawer out (Figure 6).
2.Position each bracket separately. Grasp the middle of the bracket, pull the front end up and out, then forward to remove it.
3.Place bracket at desired location. Push the bracket rear hook into the rear mounting slot, then set front of the bracket in the front slot.
4.Repeat for other brackets.
5.Push extenders completely into brackets. Align the shelf/drawer grooves with the extenders and slide completely into the unit.
Lift one tab on extender UP while pushing tab on opposite extender DOWN and pull out to remove.
To remove brackets, remove shelf, lift front of bracket to disengage the front key slot, then pull forward to disengage the rear key slot.
Figure 5. Shelving/Drawer Adjustment
DOOR OPTIONS
Perlick residential units offer a variety of door panel design alternatives; solid stainless steel, solid wood overlay, glass with stainless steel trim and glass with wood overlay trim.
Solid stainless steel and stainless steel glass doors are shipped from the factory with decorative stainless steel panels and handles in place on the unit. Solid wood overlay and glass wood overlay doors are designed to accept a decorative front panel to match surrounding cabinetry and door handles.
NOTE: Wood overlay models are designed to accept wood overlay panels from your cabinetry supplier. They do not include a wood overlay. Templates are available on www.
All Perlick units (excluding beer dispenser and ice maker models) accept any of the above door configurations and are fully interchangeable. Glass door configurations are not available on beer dispenser or ice maker models.
NOTE: Glass with stainless steel trim and glass with wood trim may sweat in conditions with relative humidity over 75%.
CHANGING DOOR SWING DIRECTION
NOTE: Changing the door mount is not advisable if the door is equipped with a custom wood overlay. Doing so may result in an undesirable handle position.
To change the door swing direction, a hinge kit is required:
•Part No. 67439R - Right hinge kit
•Part No. 67439L - Left hinge kit
In addition to the hinge kit, the following tools are required:
•Large flat head screwdriver
•Regular Phillips head screwdriver
•Plastic putty knife
1). Support the door in the open position as shown in Fig. 7 on page 9. Remove the hinge pin.
2.) Pull door to the side and then lower door.
3.) Remove top and bottom hinge brackets. Retain screws for later use. See Fig. 8 on page 9.
4). Remove the hole plugs from the top and bottom hinge bracket mounting holes (see Fig. 8 on page 9). Place the plugs in the holes on the opposite side made vacant by removing the hinges in step 3.
8perlick.com
