PERLICK RESIDENTIAL INSTALLATION MANUAL
INSTALLATION
Unit may tip forward if loaded racks/shelves are all pulled out at the same time. To prevent tipping, and to provide stable installation, the unit must be secured in place with the anti-tip brackets supplied with the unit. The anti-tip brackets, when properly installed, should secure the rear legs/glides to the mounting surface and prevent the unit from tipping forward.
NOTE: Anti-tip brackets are only used for stationary cabinets and should not be installed on cabinets with accessory casters. Caster kits are available for HP, HC and HA model cabinets. Refer to the instructions supplied with the caster kit for proper installation.
NOTE: If installing on a concrete floor, concrete fasteners are required and not included with the anti-tip kit.
NOTE: Some installation sites may require modifications to provide a secure surface for attaching the brackets.
A set of anti-tip brackets is supplied with the unit. These brackets should be attached to the floor at the rear of the unit. Each bracket must be located to engage the rear glides when the cabinet is pushed back into position. Refer to Figures 1, 2 and 3 (shown below) for anti-tip bracket mounting locations.
| | 22-1/32” |
| 13-1/32” |
15/16” | | 15/16” |
|
3/16” | 3/16” |
| Figure 1. 15” Anti-tip Kit | Figure 2. | 24” Anti-tip Kit |
15/16” | 22-1/32” | 23-3/16” | 1-3/4” |
| | | | 5/16” |
3/16” | | 3/16” | 1/2“ | to hole |
Figure 3. 48” Anti-tip Kit
