Operation & Installation Manual
Signature Series (HP15 model)
PREPARING THE SPACE
Make sure that the space that the opening where the Perlick cabinet(s) is/are to be installed is properly prepared. Refer to Figures 1 and 2 on page 5 to ensure proper space dimensions and electrical service are correct for the model to be installed.
CAUTION
If cabinet is being installed under a countertop it is recommended that the countertop be supported by structure other than the refrigerated cabinet to prevent damage to the counter top.
Where a
DANGER
Failure to comply with the above electrical guidelines may result in possible injury, death, fire or loss of property.
IMPORTANT NOTE: For a cabinet door to operate properly, the door must open a minimum of 90°. Use a minimum
IMPORTANT NOTE: Make sure the floor under the unit is level with the surrounding finished floor. Protect a finished floor with plywood, cardboard or some other suitable material before moving the unit into place. Failure to do this may result in damage to the floor.
PREPARING ELECTRICAL CONNECTIONS
A 115 volt, 60Hz, 15 amp circuit breaker and electrical supply are required. A separate circuit is required for each Perlick unit installed.
Follow the National Electrical Code and local codes and ordinances when installing the receptacle.
All Perlick units come equipped with a NEMA
IMPORTANT NOTE: Never use an extension cord to extend the power cord to the electrical receptacle.
DANGER
ELECTROCUTION HAZARD
Electrical grounding is required. This appliance is equipped with a three prong (grounding) polarized plug for your protection against possible shock hazards.
•Never remove the round grounding prong from the plug.
•Never use a
•Never use extension cords to connect power to the unit.
UNPACKING AND MOVING
CAUTION
Do not cut cardboard sleeve covering the unit. Cutting may result in damage to the exterior of the cabinet.
1.Uncrate the unit outside on a flat surface. Remove the card- board sleeve by removing the banding holding the sleeve to the shipping base. Carefully lift the cardboard sleeve up over the top of the unit.
2.Carefully lift unit off base and onto a hand truck or dolly (this should be done with a minimum of two people; larger units may require additional helpers!). Make sure the unit is bal- anced on transporting device using soft, flexible strapping. Protect unit surfaces with cloth material where strapping contacts unit.
3.Before moving unit, secure door to unit with tape to keep the door closed.
4.Carefully move unit to installation site and place in front of opening.
WARNING
A minimum of two people should lift the cabinet off the base to prevent possible personal injury.
6