Operation & Installation Manual
Signature Series (HP15 model)
IMPORTANT NOTE: Dependent on the mode and configuration, the controllers have been programmed to only allow a temperature adjustment within a specified range. See chart below for the specified range allowed for your cabinet:
HP15 Models |
|
|
|
Description | Model No. | Set Point | Range |
Refrigerator | HP15RS | 38°F | 30°F to 42°F |
Beverage Center | HP15BS | 42°F | 30°F to 48°F |
Wine Reserve | HP15WS | 45°F | 40°F to 68°F |
CHECKING PRODUCT TEMPERATURE | CLEANING AND OTHER MAINTENANCE |
To accurately check the temperature of product stored in the refrigerated compartment insert an accurate thermometer into a plastic
Place the bottle in the desired area for 24 hours. Refrain from opening the unit during testing period. After 24 hours, check the temperature of the water. Adjust the control settings if necessary.
You Perlick unit is
•Temperature setting
•Room temperature where installed
•Number of times the door is opened and closed
•Length of times the door is left open
•Style of door installed
•Door gasket sealing and condition
•Amount of time the internal light is illuminated
•Installaion in direct sunlight or near a heart source
CAUTION
Shut off electricity to the unit before cleaning the condenser and other routine maintenance.
To clean stainless steel exterior or interior surfaces, use a soft, non- abrasive stainless steel cleaner to wipe down the surfaces. If you have difficulty finding a good cleaner, try Signature Polish from Signature Limited Laboratory, P.O. Box 13436, Dayton, OH 45413- 0436; or call
To clean interior and exterior
CAUTION
Do not use abrasive cleaners or cloths on any of the interior or exterior surfaces or removable parts.
Cleaning the Condenser
The condenser should be cleaned every three (3) months. The condenser is located behind the toe plate (Figure 6). Remove the toe plate and use a soft bristle brush and vacuum to remove the dust and lint. Avoid damaging or crushing the condenser fins or tubing. Upon completion, reinstall the
CAUTION
Failure to clean the condenser could result in temperature loss or mechanical failure. Clean this area every three months.
21