Step | Install Patio Panel |
| |
2 | 2A | Connection | 2A NOTE: If you purchased a 96” Patio |
| Bar | Panel, first assemble the bottom section | |
| to the top section before proceeding with | ||
|
| ||
|
| the installation. Remove the four factory | |
|
| installed screws from sides of connection | |
|
|
| bars on bottom door section. Align and slide |
|
|
| connection bars on bottom section into top |
| Bottom | Factory | section. Reinstall and tighten the four screws |
| through the four | ||
| Door | Installed | |
| Section | Screws | top door section into the connection bars. |
| On Each | ||
|
| Side |
|
|
|
| NOTE: Remove all packaging materials, |
|
|
| including cardboard inserts inside the height |
| 2B |
| adjuster. |
|
| 2B The Freedom™ Patio Panel Pet Door inserts | |
|
|
| into the opening in your sliding glass door |
|
|
| against the doorjamb. Your sliding glass door |
|
|
| will close against the Patio Panel. |
|
|
| With sliding glass door open, insert top of Patio |
|
|
| Panel with height adjuster into upper door track |
|
|
| on interior side of sliding glass door. Lift up and |
|
|
| position bottom of Patio Panel into lower door |
|
|
| track on interior side of the sliding glass door. |
|
|
| Ensure the side of the Patio Panel showing |
|
|
| flap screw heads is on the interior side of your |
|
|
| sliding glass door. |
NOTE: You may need to pull down the height adjuster to fit the Patio Panel in your sliding glass door track. Firmly pull down one side and then the other.
2C
2C Move the Patio Panel against the doorjamb.
The Patio Panel should fit flush against the doorjamb without any gaps. Make sure the height adjuster is fully extended and not tilted to one side. Ensure you are satisfied with the fit of the Patio Panel before drilling
6 |
