Petsafe PPA11-13123 Attach the Patio Panel, Step, 3B To install the Patio Panel into an exposed

Step	Attach the Patio Panel
3	3A	Height			3A Slide the Patio Panel out slightly from
					door jamb to show pre-drilled holes in height
		Adjuster	Pre-drilled
			Holes		adjuster. Drill 7/64” (2.5 mm) holes through the
					two pre-drilled holes on interior side of height
					adjuster. Secure height adjuster to Patio Panel
					using two 5/8” sheet metal screws. Slide Patio
					Panel back against door jamb. Make sure it is
					flush without any gaps.
	3B				NOTE: If installing the Patio Panel into
				12"	a recessed sliding glass door frame,
					contact our Customer Care Center or visit
				30.48 cm
					www.petsafe.net for a Metal Bracket Kit,
					MPA00-12891 and installation instructions.
					NOTICE

1"	Prior to installation and drilling, consult your
	sliding glass door manufacturer’s warranty.
2.54 cm
	Unauthorized changes or modifications may
	void the warranty. Installing screws into vinyl
	door frames or door jambs may crack the vinyl.
	3B To install the Patio Panel into an exposed
	sliding glass door frame, find the Patio Panel
	center at top and mark on the sliding glass

door frame. Measure 12” from the top down the side of sliding glass door frame and mark. Measure 1” above the pet door in the Patio Panel and mark on the sliding glass door frame. Measure the center of the Patio Panel at the bottom and mark on the sliding glass door frame.

3C	3C Drill 9/64” (3.5 mm) clearance
	holes through your sliding glass

door frame ONLY at the locations you just marked. DO NOT DRILL INTO THE PATIO PANEL AT THIS TIME.

www.petsafe.net7