5
3 POWER SUPPLY
There are two sources of power for 100WT10P operation:the battery and the AC adapter.
3.1 AC
You may operate your 100WT10P with AC power in two different ways.Mounted in the base station, or
connected directly to the AC adapter.To run your 100WT10P on the base station,place the pad into and
connect the AC adapter to the jack at the rear of the base station.To plug the product directly to the AC
adapter,locate and plug into the DC-in jack at the lower left corner of the product,under the orange
rubber protector.
3.2 Battery
3.2.1. When using the 100WT10P for the first time, it is advisable to charge the battery for at least 5
hours.
3.2.2. After the initial charging, when not in use, the 100WT10P takes approximately two hours to fully
charged;it takes 3 hours to fully charged while in use. A fully charged battery lasts up to 4 hours.
3.2.3. The power light on the top right indicates the level of battery charge.
Turn on the power to see the power light.
Full charge The power light is solid green.
Low chargeThe power light is blinking green when the battery's remaining charged falls to less
than 6 percent.
Critical low chargeThe power light blinks amber when the charge falls under 3 percent.
If your 100WT10P is powered up and immediately enters the suspend mode,it means the
battery is uncharged.To avoid loss of data in memory,fully charge the unit within 24 hours.
CAUTION: Recharge the 100WT10P any time a low charge warning appears.
Failure to recharge the battery will result in loss of data contained in internal memory (RAM).
3.2.4. In order to optimize battery operation, open only the applications you are actually using.
To conserve battery power,disable WLAN when it's not in use.
3.2.5. To change battery
1.Suspend your 100WT10P by turning the power switch to the OFF position.
2.Unlock the battery latch 1
3.While one hand holds the battery latch two in the unlocked position, use the other hand to pull
the battery out of the slot.
4.Replace with another battery
NOTE:When fully charged and not in use, your 100WT10P has a life of one week.
CAUTION:
1.Suspend your 100WT10P before removing or changing the battery pack.
2.To avoid loss of data in memory,insert a charged battery in 24 hours.