26
Information for UK only
WARNING! THIS APPLIANCE MUST BE EARTHED.
Important:
This apparatus is supplied with an approved moulded 13A plug.
To change a fuse in this type of plug proceed as follows:
1 Remove fuse cover and fuse.
2 Fit new fuse which should be a BS 1362 5A,A.S.T.A.or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets,it should be cut off and an appropriate 3-pin plug
fitted in its place.
If the mains plug contains a fuse,this should have a value of 5A. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5A.
Note:The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A
socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in accordance with the following code:
BLUE - “NEUTRAL” (“N”)
BROWN - “LIVE”(“L”)
GREEN & YELLOW - “EARTH” (“E”)
1 The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with
the letter “E” or by the Earth symbol or coloured GREEN or GREEN AND YELLOW.
2 The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured
BLACK.
3 The BROWN wire must be connected to the terminal which marked with the letter “L” or
coloured RED.
Before replacing the plug cover,make certain that the cord grip is clamped over the sheath of the lead - not
simply over the three wires.
End-of-Life Disposal
Your new monitor contains materials that can be recycled and reused.Specialized companies can recycle your
product to increase the amount of reusable materials and to minimize the amount to be disposed of.
Information for US and Canada
This product may contain lead and/or mercury. Dispose of in accordance to local-state and federal
regulations.
For additional information on recycling contact www.eia.org (Consumer Education Initiative)
Please find out about the local regulations on how to dispose of your old monitor from your local
Philips dealer.
APPENDIX D:REGULATORY INFORMATION