1. Connecting the TV-Video Combi
Important for the United Kingdom
This apparatus is fitted with an approved 5 Amp plug. To change a fuse in this type of plug proceed as fol- lows:
1.Remove fuse cover and fuse.
2.Fix new fuse which should be a BS1362 5A,ASTA or BSI approved type.
3.Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A.
The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere.
How to connect a plug:
The wires in the mains lead are coloured in accordance with the following code:
BLUE- 'NEUTRAL' ('N')
BROWN- 'LIVE' ('L')
4.The BLUE wire must be connected to the ter- minal which is marked with the letter 'N' or coloured BLACK.
5.The BROWN wire must be connected to the terminal which is marked with the letter 'L' or coloured RED.
6.Do not connect either wires to the earth ter- minai in the plug which is marked with the let- ter 'E' or by the safety earth symbol or coloured green or
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the
1.Take the remote control and the enclosed batteries (2 batteries).
2.Open the remote control's battery compart- ment and place the batteries in it as shown in the picture and close the battery compart- ment.
The remote control is now ready to use. Its range is approximately 7 metres.
Connecting the cable
1.Insert the aerial cable plug into the AERIAL at the back of the
2.Connect the mains cable to the wall socket.
3.If the little red standby light (STANDBY 
) at the front panel of the set is not lit, please switch on the set using the main power switch. The power switch 
is located on the left side panel of the set.
This text will appear on the TV screen.
PLEASE CONNECT AERIAL OR
CABLE TO THE TVCR
THEN...
PUSH P+ KEY
OR...
FOR PLAY ONLY PUSH PLAY
You can find more details in chapter 'Preparation for use'.
Preparing the remote control for operation
The remote control and its batteries are packed sepa- rately in the original
Connecting additional devices
You can connect additional devices such as decoders, satellite receivers, camcorders, etc. to the EXT1 socket.
The respective scart socket is usually marked 'AV' or 'TV' on the decoder or satellite receiver.
3 | EN |
