Parental control (Child lock)
This function protects your
Programmed recordings will still be recorded (in spite of the parental control) and cannot be interrupted.
1.Press |
| MENU | . |
|
| ||||||
|
|
|
| ||||||||
The main menu will appear. | |||||||||||
2.Use |
|
|
|
|
|
|
|
| to select 'GENERAL SET | ||
| K B |
|
| L C |
| ||||||
|
|
|
|
|
|
|
|
| |||
UP'. Then press |
| . | |||||||||
B 1 | |||||||||||
3. Use |
|
|
|
|
|
|
|
| to select 'CHILD LOCK'. | ||
K B |
|
| L C | ||||||||
|
|
|
|
|
|
|
| ||||
4.Use B 1 to select 'ON'.
'If a button at the front of the machine is pressed while parental control is active, ’CHILD LOCK ACTIVE’ will appear on the screen for a few sec- onds.
9. Before you call an engineer
If, contrary to expectation, you have any problems using this
Your
*There is no power supply: check the power supply. *Parental control is on:Switch the parental control off. *There is a technical problem: disconnect from the mains power supply for 5 minutes, then
If this doesn't help, you can reset your
Resetting devices to default factory settings *Warning: by doing so you will the information stored (TV channels, time and date, TIMER) will be cleared.
1.Switch the
same time for 2 seconds or more.
Cassette is jammed in the
Remote control does not work
*Remote control is not pointed at the
*Take out the batteries, wait for 10 seconds and place them back in the remote control. *Batteries have run out. Change the batteries.
No picture when you play a cassette
*There is no recording on the cassette.
Poor picture quality when you play a cas- sette
*The cassette is badly
*Tracking is not properly adjusted. Turn to sec- tion ‘Manual Tracking’.
*Warning, if the tape quality is too bad, the message ‘Use cleaning tape’ will permanently appear on the TV screen. If, nevertheless, you want to see the tape content, press P+ or
No recording possible
*The TV channel you want to record is not stored or you selected the wrong programme number: check TV channels stored.
*A cassette was inserted that does not have the security tab (cannot be used to record): Insert a cassette with an intact security tab or change cassette. For more information, please see the section ‘Preventing accidental erasing of cas- settes’ in chapter ‘Manual Recording’. *’VPS/PDC’ switched on but ‘VPS/PDC time’ wrong: enter ‘VPS/PDC time’ exactly to the minute. Check your aerial connection.
The wrong TV channel has been recorded after you programmed a recording using PlusCode number
1.Enter the PlusCode number you wanted to record.
2.Confirm with B 1 .
3.Check the programme number/channel name in the ‘PROG.’ input field.
4.If this does not correspond to the desired TV channel, select the input field and change the programme number/channel name.
5.Confirm with B 1 .
Smart Clock does not work
*You have stored on programme number ‘P01’ a TV channel that does not transmit TELETEXT. Store on ‘P01’ a TV channel that transmits
TELETEXT.
*Poor TELETEXT reception. Store a TV channel on ‘P01’ with good TELETEXT reception.
*You have not activated the Smart Clock func- tion. Switch the function ‘ON’.
You can also call the customer service centre in your country.The telephone numbers can be found on the back of this instruction manual.
Have the model number (MODEL NO) and the production number (PROD.NO.) of your TV- Video Combi ready.
EN | 18 |
