Philips 245P2 Troubleshooting & FAQs, The Auto Function is not applicable in, Common Problems

7.	Troubleshooting & FAQs	AUTO button doesn't function
		• The auto function is applicable only in
			VGA-Analog mode. If the result is not
7.1	Troubleshooting		satisfactory, you can do manual adjustments
This page deals with problems that can be			via the OSD menu.
corrected by a user. If the problem still persists			Note
after you have tried these solutions, contact Philips			The Auto Function is not applicable in
customer service representative.			DVI-Digital mode as it is not necessary.
	Common Problems	Visible signs of smoke or sparks
No Picture (Power LED not lit)		• Do not perform any troubleshooting steps
		• Disconnect the monitor from mains power
•	Make sure the power cord is plugged into the		source immediately for safety
	power outlet and into the back of the monitor.	• Contact with Philips customer service
•	First, ensure that the power button on the		representative immediately.
	front of the monitor is in the OFF position,
	then press it to the ON position.		Imaging Problems
No Picture (Power LED is white blinking)		Image is not centered
•	Make sure the computer is turned on.	• Adjust the image position using the “Auto”
•	Make sure the signal cable is properly		function in OSD Main Controls.
	connected to your computer.	• Adjust the image position using the Phase/
•	make sure the monitor cable has no bent pins		Clock of Setup in OSD Main Controls. It is
	on the connect side. If yes, repair or replace		valid only in VGA mode.
	the cable.
•	The Energy Saving feature may be activated	Image vibrates on the screen
Screen says		• Check that the signal cable is properly securely
			connected to the graphics board or PC.
		Vertical flicker appears
•	Make sure the monitor cable is properly
	connected to your computer. (Also refer to
	the Quick Set-Up Guide).	• Adjust the image using the “Auto” function in
•	Check to see if the monitor cable has bent		OSD Main Controls.
	pins.	• Eliminate the vertical bars using the Phase/
•	Make sure the computer is turned on.		Clock of Setup in OSD Main Controls. It is
			valid only in VGA mode.

50