9. Maintenance
7.Grasp the lamp holder handle and carefully pull the lamp holder out of the projector.
Resetting the lamplife time
1.Press Menu.
–The menu bar appears on the screen.
2. Use cursor control to |
|
|
|
| |
select Settings in the | Display | Picture | Audio | Settings | |
menu bar. | |||||
|
|
|
|
Language
Keystone correction
Lamp counter
System information...
Factory reset (more)
8.Carefully remove the new lamp housing from its package. Do not touch lamp or point lamp housing opening at anyone. Do not drop, as the impact may cause the lamp to break.
9.Place the lamp holder in the guiding slots and insert into the lamp compartment.
3.Use cursor control to select Lamp counter in the sub menu.
Display Picture
Language
Keystone correction
System informatyion...
Factory reset (more)
Lamp
0 hours
Audio Settings
Projector 2453 hours
10.Tighten the screws.
11.Replace the cover and tighten the screws.
12.Plug the projector back in by inserting the mains lead in the Mains socket.
13.Press the Stand by On button to switch on the projector.
14.Reset the lamp life time (see ‘Resetting the lamplife time’).
15.Properly dispose of the old lamp.
Notes:
–When replacing the lamp, always use the same type of lamp LCA3111/00, 12NC 8670 931 11009).
–Please dispose of lamp in special chemical disposal bins.
Lamp counter shows the operating hours of the lamp. It is suggested to reset when a new lamp is inserted. To reset keep OK key pressed
for 3 seconds.
4.Press OK for 3 seconds to reset the lamp counter.
5.If required, select another item you wish to adjust or press Menu to exit.
22
