14
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note: EXT.1 can handle CVBS and RGB, EXT.2 CVBS and Y/C. It is preferred to connect peripherals with RGB
output to EXT.1 as RGB provides a better picture quality.
If your recorder is provided with the Easylink function, it should be connected to EXT. 2 to benefit from the EasyLink
functionality.
Recorder (VCR-DVD+RW)
Connect the aerial cables 1,2and, to obtain the optimum
picture quality,eurocable 3as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder’s test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation,p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4to your decoder and to the special
euroconnector of your recorder.See also the recorder handbook.
See Decoder,p. 8. You can also connect your decoder directly to
EXT.1 or 2with a eurocable.
Other equipment (satellite receiver,decoder,DVD, games,etc.)
&Connect the aerial cables 1,2and 3as shown (only if
your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4or 5to one of
the euroconnectors EXT.1or 2to obtain a better picture
quality.
éLook for the test signal of your peripheral in the same way as
you do for a recorder.
“Make a selection in the Setup,Source menu, p.8.
Side connections Camera or Camcorder
&Connect your camera or camcorder as shown.
éConnect to VIDEO 2and AUDIO L 3for mono equipment.
For stereo equipment also connect AUDIO R 3.
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the S-video input 1and
audio inputs 3.
Do not connect cable 1and 2at the same time.This may cause
picture distortion !
Headphone
&Insert the plug into the headphone socket Las shown.
éPress ¬on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.The
headphone socket has a 3.5 mm jack.
In the Sound menu select Headphone volume to adjust the
headphone volume.
CABLE
1
4
2
EXT.
2
3
CABLE
12
1EXT.
2
45
3
1
3
2
Connect Peripheral Equipment
2224.1 gb 11-02-2003 08:55 Pagina 14