8.
9Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
10Brush the slots of the razor head.
For optimum performance, razor cutters and heads should be cleaned in a degreasing liquid (e.g. Norelco Razor Cleaner or alcohol) and lubricated with Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head).
11Replace the cutter into head section. Slide razor head back into frame making sure that flat rim of cutting heads slides under 2 clamps on frame.
12Repeat the process for the other two razor heads (cutters and heads).
13Replace the frame.
14 Press down and turn the wheel clockwise until it locks into place.
15 Replace the Razor Head Assembly back on razor.
9.
After Each Use:Trimmer
1Turn razor OFF.
2Push Trimmer Slide Switch up to
3Clean Trimmer with the brush every time you use it.
4Lubricate the Trimmer teeth with Norelco Razor Lubricant (model AL80), or with one drop of mineral oil every 6 months.
5Close Trimmer by sliding Trimmer switch down.
