Power Supply General Operation / Tuner
Using AC power
WArNINg: Always check you have
completely switched off the set, before
you change or disconnect power supply.
1 Check if the power voltage, as shown on
the type plate located on the bottom
of the set, corresponds to your local
power supply. If it does not, consult your
dealer or service center.
2 Connect the power cord to the AC
MAINS~ inlet and the wall socket. The set
is now connected and ready for use.
3 To switch the set off completely, withdraw
the power cord from the wall socket.
4 Install the unit near the AC outlet and
where the AC power plug can be easily
reached.
• Disconnectthepowercordfromthewall
socket to protect your set during heavy
thunderstorms. Children could seriously
injure themselves as the free end of the
cable may still be live if only the connector
is removed from the MAINS socket at the
back of the unit.
The type plate is located on the bottom
of the set.
Helpful hints:
–
To avoid unnecessary energy consumption,
always adjust the
Source selector
to
OFF
after using the set.
General operation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selector to: CD, FM or
MW.
2 To switch off the set, adjust the Source
selector to
OFF
position.
3 To switch to LINE IN mode, connect
an external audio source to the LINE-
IN inlet.
Helpful hints:
• ThesetswitchestoLINE IN mode
automatically when an external audio source
is connected, no matter the set is in CD,
FM or
MW
mode.
• TheLINE-IN inlet is not for earphones.
Adjusting volume and sound
Adjust the sound with the VOLUME and
DBB controls.
Radio reception
1 Adjust the Source selector to FM or
MW.
2 Turn TUNING to tune to a station.
Helpful hints:
To improve radio reception
• ForFM, extend, incline and turn the
telescopic antenna for best reception.
Reduce its length if the signal is too strong.
• For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.