•When the HDMI OUT jack is outputting the video in 1080p/24, picture will not be output from the VIDEO OUT jack.

•When connected to an HDCP incompatible display device, the picture will not be displayed properly.

•The audio signals from the HDMI OUT jack (including the sampling frequency, the number of channels and bit length) may be limited by the device that is connected.

•Among the display device(s) that support HDMI, some do not support audio output (for example, projectors). While connected to a device such as a projector, audio will not be output from the HDMI OUT jack.

•When this unit’s HDMI OUT jack is connected to a DVI-D compatible display device(s) (HDCP compatible) with an HDMI-DVI converter cable, the signals are output in digital RGB.

•When you make a selection, the TV monitor temporarily goes blank and then comes back again. If it does not come back, press [HDMI] repeatedly to change the resolution or touch and hold [B (play)] on the front panel for 5 seconds to change the setting back to its default.

•When playing back a Frame Sequential 3D Disc, video resolution of output picture will depend on contents on the disc. (“HDMI Video” setting is not applicable for Frame Sequential 3D Discs.)

Copyright protection system

To play back the digital video images of a BD-video or DVD-video via an HDMI connection, it is necessary that both the player and the display device (or an AV receiver / amplifier) support a copyright protection system called HDCP (high-bandwidth digital content protection system). HDCP is copy protection technology that comprises data encryption and authentication of the connected AV device. This unit supports HDCP. Please read the operating instructions of your display device (or an AV receiver / amplifier) for more information.

12.3. Network Installation

(home) A “Setup” A “Network Setup” A

“Network

Installation”

Set up network connection settings in order to use BD-Live™, Netflix / Film Fresh / Blockbuster / VUDU / Pandora or network update function.

￿Connection Test

After you enable a network connection or change the network settings, always perform the connection test to check if the connection is correctly made.

1.Use [K / L / s / B] to select “Setup” in the home menu, then press [OK].

2.Use [K / L] to select “Network Setup”, then press [OK].

3.Use [K / L] to select “Network Installation”, then press [OK].

4.Use [K / L] to select “Connection Test”, then press [OK].

•Connection test will start automatically and the test result will appear right after the connection test finishes.

-“Connecting...” : The test is in progress.

-“Pass” : Connection test is successfully completed.

-“Failed” : Connection test failed. Check the connection settings.

5.Press [OK] to go back to the setup menu, or press [ (home)] to exit.

EN

EN - 43