Philips cBright 2 Series manual Other settings, Operation

8. Operation Other settings

Other Settings

The projector is equipped with the following functions to optimize its use and handling:

Start-up screen

This function allows you to display or suppress the default Philips start-up screen upon the projector’s start up and to select and store a start up screen of your own choice.

1.Press Menu.

–The menu bar appears on the screen.

2.Use Cursor Control to move the cursor to Settings.

3.Select Start-up screen by using Cursor Control.

4.Select:

Default - to display the default Philips start-up screen; Black - to suppress the default screen;

Custom - to display a start-up screen of your own choice (if loaded);

Load.. - to load the currently shown image and store it as start-up screen.

5.Press Menu to close the On Screen Display.

System information

The System Information sub menu contains an overview of the most relevant projector settings, including information on the hardware and software configuration.

1.Press Menu.

–The menu bar appears on the screen.

2.Use Cursor Control to move the cursor to Settings.

3.Use Cursor Control to move the cursor to System Information and press OK.

–The System Information overview appears on the screen.

4.Press OK to return to the menu or press Menu to close the On Screen Display.

Factory reset

This function is used to reset all user settings to the default factory settings.

1.Press Menu.

–The menu bar appears on the screen.

2.Use Cursor Control to move the cursor to Settings.

3.Select Factory reset by using Cursor Control.

4.Press OK for 3 seconds to reset all user settings.

5.Select the next item to be adjusted in the sub menu or press Menu to close the On Screen Display.

Auto Standby

This function allows you to switch off Auto Standby mode or to select the delay time after which the projector automatically switches to Standby.

Auto Source

This function allows you to switch automatic source selection on or off.

Keystone correction

Adjusts the shape of the displayed picture, when projecting upwards or downwards.

Lamp counter

Shows the operating time of the lamp, which can be reset after a new lamp has been installed. This menu item also shows the total number of hours that the projector has been used, which cannot be reset.

Data input

Selects between Computer and Component video input via the Data in connector.

Feedback

This function allows you to suppress OSD messages. Warning or error messages however are never suppressed.

Key lock

Key lock is used to de-activate all remote and local controls. To disable the keylock function keep the OK button pressed for 10 seconds.

19