Lamp Replacement

Lamp

When operation time reaches the last 100 hours

of the average lamplife, the	Multimedia projectors
message ‘Warning: lamplife	Warning:
has almost expired’ will be	Lamplife has almost expired
displayed on the screen,	It is suggested to have a spare lamp available.
each time the projector is	The lamp type is indicated in the user guide.
switched on. The lamp
indicator lights up orange.

The lamplife remaining can be checked using the OSD

–The remaining lamplife Lamp counter shows the operating hours of the

	hours are displayed in	lamp. It is suggested to reset when a new lamp is
	the action window at the	inserted. To reset keep OK key pressed
	the action window at the	for 3 seconds.
	bottom of the screen.
	– When the lamplife has
	– When the lamplife has
	expired,the lamp
	indicator lights up red	Multimedia projectors
	and the message	Warning:
	‘Warning: lamplife has	Lamplife has expired
	expired’ is displayed on	It is suggested to change the lamp,
	the screen.	It is suggested to change the lamp,
	the screen.	to avoid sudden failure and to improve
		overall picture quality.

Caution!

–For cooling purposes the lamp is open. When removing the lamp do not tilt. If the inner tube is broken glass particles may fall out.

–Be very careful. The lamp and lampholder may still be too hot to touch.

–Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening at anyone.

–A high-pressure lamp may break if handled improperly.

1.Press the Stand by button to switch off the projector.

– The standby indicator lights up red.

2.Wait 5 minutes for the lamp to cool down and the cooling fan to stop and disconnect the mains lead and all other cables.

3.Turn the projector over. Never place the projector on the side where the connections are located!

4.Unscrew the screws at the bottom of the cover and remove the cover.

5.Read the caution and warning labels on the lamp cover.

6.Unscrew the lamp holder.