Hooking Up the TV/VCR, Rod Antenna | Philips CCA132AT instruction

6 Hooking Up the TV/VCR

1

Hook up your TV/VCR using one of the connections shown.

A.

Hooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna

Connect a Cable signal or an antenna to the ANT(enna) Jack.

ANT.

B.

Connect the Cable signal to the IN Jack on the Cable Box.

Hooking Up Your TV/VCR With a Cable Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

Connect an RF coaxial cable (75- ohm, not supplied) to the OUT Jack on the Cable Box and to the ANT(enna) Jack on the TV/VCR.

OUTIN

RF coaxial cable

(not supplied)

ANT.

C.

Hooking Up Your TV/VCR With an Indoor Antenna

To install a rod antenna (not sup- plied), push the stem of the antenna into the antenna hole on the top of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Rod Antenna

(not supplied)

ANT.

Image 6

Philips CCA132AT owner manual Hooking Up the TV/VCR, Hook up your TV/VCR using one of the connections shown, Rod Antenna

Contents

CCA132AT Dear Philips Magnavox product owner For Customer Use Introduction FeaturesSafety Precautions Philips Consumer Electronics Company recommends that Table of Contents TV/VCR Maintenance Putting Batteries in the Remote ControlUsing the Remote Control Erasure Prevention Hook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Hooking Up the TV/VCR cont’d Crooked Pin Straight Pin You cannot set up channels if you are using a Cable Box Turning On the TV/VCRTons to select another channel Press the Menu button Press the STATUS/EXIT button Automatic Channel Setup Adding/Deleting Channels Press the PLAY/ o button or the STOP/ p button to selectPress the STATUS/EXIT button once or twice Setting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Setting the Clock cont’d Automatic PBS Channel Selection Wait for the TV/VCR to find the time Manual PBS Channel Selection Press the PLAY/ button or the STOP/ button to Select SET PBS CH. MANUAL. Then, press the F.FWD/B Daylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons STATUS/EXIT Button STOP/ ButtonREWind/ Button Menu Button Adjusting the Picture Controls More brilliant Adjusting the Picture Controls cont’dDecrease Increase Softer If you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFF Press the PLAY/ button or the STOP/ button to select Reminder Playing Recording options are on pages RecordingGiven below Distortion may appear on the tape One-Touch Recording Rerecording Tape Duplication Different brands of equipment may operate differentlyAudio and video cables are not included Timer Recording Daily Timer Recording cont’d Rect information Timer Recording cont’d Checking or Clearing Timer Recordings With the TV/VCR on, press the Menu button Defeat Recording Repeat Play B Repeat Play Insert a tape in the TV/VCR Press the Menu button Repeat Play cont’d Press the STATUS/EXIT button to remove the display. a Real-Time Counter Memory Press the STATUS/EXIT button. The real-time counter will Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still Picture SmartLock SmartLock cont’d Example Specific Ratings To change the access code, follow these steps Blue Background Ground Setting the Sleep Timer If the power fails, you might lose Sleep timer setting Volume Bar Menu Closed CaptionExample Screen May be delayed for a few seconds Closed Caption cont’d Automatic Operation Features Specifications Glossary Helpful Hints Helpful Hints cont’d Limited Warranty TV/VCR Combination Channel Above Adding Deleting Reviewing Setup Buttons Index Supplied Accessories